Quantum Dot Source-Drain Transport Response at Microwave Frequencies | Physics TomorrowUnlock the full length paper at here Submitted - 06 November 2022Reviewed - 02 February 2023Accepted - 20 March 2023Introduction. The ability to detect single electrons in the solid state is useful for a variety of applications, including spin qubit readout [1–4], electrical current and capacitance standards [5, 6], studying cooper pair breaking [7–9], single-shot photodetection [10–13], and nanothermodynamics and fluctuations [14– 19]. While many methods exist to detect charge, one of the main ways are by utilizing quantum dots (QD). These systemsmake excellent charge detectors due to their high sensitivity and well-established transport theory [20, 21], allowing detectors to be made predictable and with a well-understood operation principle. Originally, measurements were performed at DC, relying on a difference in current for the readout resulting in a bandwidth up to some kHz [6, 22]. In the last two decades, the readout methods have moved towards measuring the reflected power in a high-frequency tank circuit with resonant frequency in the 100 MHz - 1 GHz range. This results in bandwidths in the MHz range allowing for µs time resolution [23–25]. The response of the system in these studies is still governed by the low frequency response of the system, i.e. the admittance Y(ω) is equal to the DC conductance G of the system. In this article, we increase the QD sensor frequency to the 4 - 8 GHz frequency range where the cavity photon energy h¯ω is greater than the thermal energy kT . This opens up the avenue to increase the bandwidth correspondingly by an order of magnitude, yielding possibly a time resolution sufficient to probe the electron position in DQD systems within the recently achieved coherence times [27, 28]. The pioneering works have considered the dispersive response of the QD at these frequencies motivated mostly by quantum capacitance effects . In this article, we focus on the dissipative part that yields a stronger response, making it useful for charge readout . We present experimental results for two devices and show that for both of them at sufficientlylarge tunnel couplings that we are lifetime broadened, Γ > kT, the low frequency result of Y(ω) = G still applies. However, when the device is tuned to the thermally broadened limit where the tunnel couplings Γ < kT, the measured admittance is qualitatively different from the DC conductance, displaying a linewidth of 2h¯ω in the QD level tuning and a factor two difference in admittance depending on the direction ofthe level shift of the quantum dot relative to the leads ε, attributed to spin degeneracy. These results are well captured by sequential tunneling theory, directly evaluating the admittance for a QD subjected to a time-periodic drive , or using P(E) theory in which the admittance is inferred from the absorption in the cavity [31, 32]. Lastly, we show in the other device which exhibits asymmetric tunnel couplings where theDC transport is suppressed while remaining lifetime broadened, the AC response in this device remains large, in line with Ref. 26, indicating a potentially useful consequence of probing QD devices at high frequencies. This response falls in a regime where neither non-interacting scattering theory nor sequential tunneling models are applicable.